PARKING BRAKE PEDAL (for LHD) > REMOVAL

for Preparation Click here



1. REMOVE AIR CONDITIONING UNIT ASSEMBLY
(Click here)


2. REMOVE MULTI-MEDIA MODULE ASSEMBLY (w/ Navigation System for DVD)


    E220517

  1. Disconnect the 2 connectors.

  1. Remove the 4 bolts and multi-media module assembly.



3. REMOVE NO. 1 ELECTRICAL KEY OSCILLATOR


    B266770

  1. Disconnect the connector.

  1. Disengage the clamp and remove the No. 1 electrical key oscillator.

    NOTICE:
    Be careful when removing the electrical key oscillator. If the oscillator is dropped, replace it with a new one.



4. REMOVE MULTI-MEDIA INTERFACE ECU ASSEMBLY (w/ Audio)


    E220812

  1. Remove the bolt.

  1. Disconnect each connector.

  1. Disengage the guide and remove the multi-media interface ECU assembly.



5. REMOVE NO. 2 CONSOLE BOX MOUNTING BRACKET


    C233602

  1. Disengage the clamp.

  1. Remove the 2 bolts and No. 2 console box mounting bracket.



6. REMOVE YAW RATE AND ACCELERATION SENSOR


    C208052

  1. Remove the 2 bolts and yaw rate and acceleration sensor.

  1. Disconnect the connector from the yaw rate and acceleration sensor.



7. REMOVE FRONT FLOOR CENTER REINFORCEMENT


    C232728

  1. Remove the 4 bolts and front floor center reinforcement.



8. LOOSEN ADJUSTING NUT


    C232729E01

  1. Remove the lock nut and loosen the adjusting nut.
    Text in Illustration 
    *1
    		Lock Nut
    *2
    		Adjusting Nut



9. SEPARATE NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY


    C232720E01

  1. Separate the No. 1 parking brake pull rod sub-assembly from the parking brake control pedal assembly as shown in the illustration.
    Text in Illustration 
    *a
    		Turn
    *b
    		Hold



10. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY


    C232734

  1. Remove the 5 bolts and nut, and separate the No. 1 parking brake cable assembly.

  1. Disengage the cable from the clamp.



    C232730

  1. Disconnect the parking brake switch connector.

  1. Disengage the wire harness clamp.



    C232731

  1. Remove the bolt, 2 nuts and parking brake control pedal assembly.