DTC    C1582    Assist Map Number Mismatch

for Preparation Click here


DESCRIPTION

When an incorrect power management control ECU is installed after the assist map has been recorded in the power steering ECU assembly, then DTC C1582 is stored because the data does not match the vehicle specifications.

DTC No.
DTC Detection Condition
Trouble Area
C1582
Assist map number mismatch
  1. Power steering ECU assembly
  2. CAN communication system
  3. Power management control ECU

INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly has been replaced with a new one, perform rotation angle sensor value initialization and torque sensor zero point calibration (Click here).

1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)

  1. Using the intelligent tester, check for DTCs and confirm that there are no problems in the CAN communication system (Click here).

    OK:
    DTC is not output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK


2.CHECK POWER MANAGEMENT CONTROL ECU

  1. Check if a power management control ECU that complies with the vehicle specifications is installed.

    OK:
    A power management control ECU that complies with vehicle specifications is installed.



NG
REPLACE POWER MANAGEMENT CONTROL ECU (Click here)
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)