DTC    B2343    Position Initialization Incomplete

for Preparation Click here


DESCRIPTION

This DTC is output when the sliding roof ECU (sliding roof drive gear assembly) has not been initialized.

DTC No.
DTC Detection Condition
Trouble Area
B2343
Sliding roof ECU (sliding roof drive gear assembly) has not been initialized.
Sliding roof ECU (Sliding roof drive gear assembly)

WIRING DIAGRAM

Refer to DTC B2341 (Click here).

INSPECTION PROCEDURE

NOTICE:
  1. When DTC B2342 and B2343 are output simultaneously, perform troubleshooting for DTC B2342 first.
  2. When the sliding roof ECU (sliding roof drive gear assembly) is removed and reinstalled or replaced, it requires initialization (Click here).
  3. The sliding roof system uses the CAN and LIN communication systems. First, confirm that there are no malfunctions in the CAN and LIN communication systems. Refer to the How to Proceed with Troubleshooting procedure (Click here).

1.INITIALIZE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY)

  1. Check that the sliding roof ECU (sliding roof drive gear assembly) can be initialized (Click here).

    OK:
    Sliding roof ECU (sliding roof drive gear assembly) can be initialized.



NG
REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY) (Click here)
OK


2.CHECK SLIDING ROOF OPERATION

  1. Check the sliding roof auto operation (Click here).

    OK:
    Auto operation operates normally.



NG
REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY) (Click here)
OK


3.CHECK DTC OUTPUT

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    DTC B2343 is not output.



NG
REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY) (Click here)
OK

END (PROBLEM DUE TO INITIALIZATION FAILURE)