PERFORMANCE DAMPER > REMOVAL

for Preparation Click here



1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
(Click here)


2. REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL (for LHD)


    C232358

  1. Disengage the 2 claws and remove the No. 1 heater air duct splash shield seal.



3. REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL (for RHD)


    C232376

  1. Disengage the 2 claws and remove the No. 1 heater air duct splash shield seal.



4. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for LHD)


    C232367

  1. Disengage the claw and guide, and remove the No. 2 heater air duct splash shield seal.



5. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for RHD)


    C232375

  1. Disengage the claw and guide, and remove the No. 2 heater air duct splash shield seal.



6. REMOVE COWL BODY MOUNTING REINFORCEMENT LH (for LHD)


    C232357

  1. Remove the 2 bolts and cowl body mounting reinforcement LH.



7. REMOVE COWL BODY MOUNTING REINFORCEMENT RH (for RHD)


    C232377

  1. Remove the 2 bolts and cowl body mounting reinforcement RH.



8. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)


    C232360

  1. Disengage the clamp and separate the wire harness.



    C232359

  1. w/ Wiper Deicer:
    Disengage the 3 clamps, disconnect the connector and separate the wire harness.



    C232361

  1. Remove the 9 bolts and outer cowl top panel sub-assembly.



9. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)


    C232378

  1. Disengage the clamp and separate the wire harness.



    C232379

  1. w/ Wiper Deicer:
    Disengage the 3 clamps, disconnect the connector and separate the wire harness.



    C232380

  1. Remove the 9 bolts and outer cowl top panel sub-assembly.



10. REMOVE SUSPENSION TOWER DAMPER


    C232232E01

  1. Remove the 2 nuts and the suspension tower damper from the vehicle.
    Text in Illustration 
    *a
    		LH Side
    *b
    		RH Side