CAN COMMUNICATION SYSTEM > Power Management Control ECU Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
Power Management Control ECU Communication Stop Mode
  1. "Hybrid Control" and/or "Power Management 1" is not displayed on the Communication Bus Check screen of the intelligent tester.
  2. Applies to Power Management Control ECU Communication Stop Mode in DTC Combination Table.
  1. Power management control ECU branch line or connector
  2. Power source circuit of power management control ECU
  3. Power management control ECU

WIRING DIAGRAM


C234614E02


C234614E01


INSPECTION PROCEDURE

NOTICE:
  1. Turn the power switch off before measuring the resistances between CAN main bus lines and between CAN branch lines.
  2. Turn the power switch off before inspecting CAN bus lines for a ground short.
  3. After the power switch is turned off, check that the key reminder warning system and light reminder warning system are not operating.
  4. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the power switch, any other switches or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
  1. Operating the power switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
  2. Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.

1.CHECK CAN BUS LINE FOR DISCONNECTION (POWER MANAGEMENT CONTROL ECU BRANCH LINE)

  1. Turn the power switch off.



    A204446E28

  1. Disconnect the H4 power management control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Switch Condition
    		Specified Value
    H4-25 (CA1H) - H4-24 (CA1L)
    		Power switch off
    		54 to 69 Ω

    Text in Illustration 
    *a
    		Rear view of wire harness connector
    (to Power Management Control ECU)



NG
REPAIR OR REPLACE CAN BRANCH LINE OR CONNECTOR (POWER MANAGEMENT CONTROL ECU)
OK


2.CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL)

  1. Reconnect the H4 power management control ECU connector.



    A251057E01

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    		Switch Condition
    		Specified Value
    A20-5 (+B1) - Body ground
    		Power switch on (IG)
    		11 to 14 V
    A19-2 (+B2) - Body ground
    		Power switch on (IG)
    		11 to 14 V

    Text in Illustration 
    *a
    		Component with harness connected
    (Power Management Control ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE TERMINAL)
OK


3.CHECK HARNESS AND CONNECTOR (GROUND TERMINAL)

  1. Reconnect the H3 power management control ECU connector.



    A204445E36

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Value
    H3-6 (E1) - Body ground
    		Always
    		Below 1 Ω

    Text in Illustration 
    *a
    		Component with harness connected
    (Power Management Control ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND TERMINAL)
OK

REPLACE POWER MANAGEMENT CONTROL ECU (Click here)