CRUISE CONTROL SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DESCRIPTION
The power management control ECU controls the cruise control system of the vehicle. The data and DTCs relating to the cruise control system can be read from the DLC3 of the vehicle. If either DTC or CRUISE OK is not displayed on the multi-information display on the combination meter when checking for DTCs, there may be a problem with either the combination meter or the CAN communication system. Use the intelligent tester to check and solve the problem.

HINT:
If a vehicle speed sensor, stop light switch or any other related part malfunctions, the power management control ECU cancels cruise control operation automatically.


CHECK DLC3

  1. Check the DLC3 (Click here).


CHECK INDICATOR


    A222996E01

  1. Turn the power switch on (IG).
    Text in Illustration 
    *1
    		Cruise Control Indicator Light

  2. Check that the cruise control indicator light turns on when the cruise control switch (ON-OFF button) is turned on, and that the cruise control indicator light turns off when the cruise control switch (ON-OFF button) is turned off.

    HINT:
    1. If the cruise control indicator check result is not normal, proceed to troubleshooting for the cruise control indicator light circuit (Click here).
    2. If a malfunction occurs in the speed sensor or stop light switch, etc., during cruise control driving, the power management control ECU activates the AUTO CANCEL of the cruise control and turns on and off the cruise control indicator light to inform the driver of a malfunction. At the same time, the malfunction is stored in memory as a diagnostic trouble code.