WASHER NOZZLE (for Rear Side) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR WASHER NOZZLE


  1. With the power switch on (READY), check that the center stream of washer fluid sprays on the windshield within the hatched area shown in the illustration.

    Standard:
    Washer fluid hits the windshield in the area shown in the illustration.



    E220053E01


    Standard Clearance 
    Area
    		Measurement
    A
    		22 mm (0.866 in.)
    B
    		6 mm (0.236 in.)
    C
    		72 mm (2.835 in.)
    D
    		108 mm (4.252 in.)