INTAKE MANIFOLD > REMOVAL

for Preparation Click here



1. REMOVE THROTTLE BODY ASSEMBLY
(Click here)


2. REMOVE EGR PIPE ASSEMBLY


    A212663

  1. Disconnect the 2 wire harness clamps.



    A212664

  1. Remove the bolt and wire harness support.



    A212665

  1. Remove the 4 bolts, EGR pipe assembly and 2 gaskets.



3. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR


    A212672

  1. Disconnect the connector.

  1. Remove the bolt and manifold absolute pressure sensor.



4. REMOVE PURGE VSV


    A212673

  1. Disconnect the connector and 2 fuel vapor feed hoses.



    A212674

  1. Remove the bolt and purge VSV.



5. REMOVE INTAKE MANIFOLD


    A212682

  1. Disconnect the 3 connectors and 2 wire harness clamps.

  1. Remove the engine oil level dipstick.



    A212681

  1. Disconnect the wire harness clamp, and then remove the 2 bolts and engine oil level dipstick guide sub-assembly.

  1. Remove the O-ring from the engine oil level dipstick guide sub-assembly.



    A212683

  1. Disconnect the fuel vapor feed hose and ventilation hose.



    A212684

  1. Remove the 2 bolts, 2 nuts and intake manifold.

  1. Remove the No. 1 intake manifold to head gasket.



6. REPLACE STUD BOLT

HINT:
If a stud bolt is deformed or the threads are damaged, replace it.



    A212685

  1. Using an E6 "TORX" socket wrench, replace the 2 stud bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }