FRONT PASSENGER SIDE POWER WINDOW SWITCH > INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY


    B203473E29

  1. Check the switch function.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      		Switch Condition
      		Specified Condition
      6 (UP) - 1 (GND)
      		Auto up or up position
      		Below 1 Ω
      7 (DOWN) - 1 (GND)
      		Auto down or down position
      		Below 1 Ω
      8 (AUTO) - 1 (GND)
      		Auto up or auto down position
      		Below 1 Ω
      6 (UP) - 1 (GND)
      		Free
      		10 kΩ or higher
      7 (DOWN) - 1 (GND)
      		Free
      		10 kΩ or higher
      8 (AUTO) - 1 (GND)
      		Free
      		10 kΩ or higher

      Text in Illustration 
      *a
      		Component without harness connected
      (Power Window Regulator Switch Assembly)
      If the result is not as specified, replace the power window regulator switch assembly (for front passenger side).



    B203473E32

  1. Check that the LED illuminates.

    1. Apply battery voltage to the power window regulator switch assembly and check that the LED illuminates.

      OK:
      Measurement Condition
      		Specified Condition
      Battery positive (+) → 4 (LED)
      Battery negative (-) → 1 (GND)
      		LED illuminates

      Text in Illustration 
      *a
      		Component without harness connected
      (Power Window Regulator Switch Assembly)
      *b
      		LED
      If the result is not as specified, replace the power window regulator switch assembly.