LIGHTING SYSTEM > OPERATION CHECK

for Preparation Click here



INSPECT INTERIOR LIGHT CONTROL OPERATION

NOTICE:
Perform this inspection with the customize parameters at the initial settings.

HINT:
The interior light control illuminates the lights below.
  1. Power Switch Illumination
  2. Front Interior Lights
  3. Rear Interior Light

  1. The operation and conditions of this control are described below.

    Operation
    		Condition
    Fade in and illuminate constantly
    		Any door is opened when all doors are closed.
    Illuminate for 15 seconds, and then fade out
    		When any of the following conditions is met, the lights illuminate for 15 seconds, and then fade out:
    1. The key enters any actuation area around the doors when the power switch is off and all doors are closed*1.
    2. Any door is unlocked when the power switch is off with all doors closed and locked.
    3. The power switch is turned from on (IG) to off when all doors are closed.
    4. All doors are closed after any door is opened and the power switch is off.
    Fade out immediately
    		When any of the following conditions is met, the lights fade out immediately:
    1. The power switch is turned from off to on (ACC) when all doors are closed.
    2. All doors are locked when the power switch is off, all doors are closed and any door is unlocked.
    3. All doors are locked again when all doors are already closed and locked.
    Battery saving
    		When no changes occur in the condition of the doors for 20 minutes and a key is not in the actuation area, the lights that operate turn off.

    HINT:
    *1: When the lights are on, if the key leaves all of actuation areas around the doors, after approximately 3 seconds, the lights fade out.


INSPECT FOOTWELL LIGHT CONTROL OPERATION

NOTICE:
Perform this inspection with the customize parameters at the initial settings.

HINT:
The footwell light control illuminates the lights below.
  1. Footwell light LH
  2. Footwell light RH

  1. The operation and conditions of this control are described below.

    Operation
    		Condition
    Fade in and illuminate constantly
    		When either of the following conditions is met, the footwell light LH and footwell light RH fade in:
    1. Any door is opened when all doors are closed.
    2. The power switch is turned from off to on (IG).
    Illuminate for 15 seconds, and then fade out
    		When any of the following conditions is met, the footwell light LH and foot light RH illuminate for 15 seconds and then fade out:
    1. Any door is unlocked when the power switch is off, all doors are closed and all doors are locked.
    2. The power switch is turned from on (IG) to off when all doors are closed.
    3. All doors are closed when any door is opened and the power switch is off.
    Fade out immediately
    		All doors are locked when the power switch is off, all doors are closed and any door is unlocked.


INSPECT CENTER CONSOLE SPOT LIGHT CONTROL OPERATION

NOTICE:
Perform this inspection with the customize parameters at the initial settings.

HINT:
The center console spot light control illuminates the light below.
  1. Center console spot light

  1. The operation and conditions of this control are described below.

    Operation
    		Condition
    Fade in
    		When either of the following conditions is met, the center console spot light fades in.
    1. The power switch is on (ACC).
    2. The power switch is on (IG).
    Fade out
    		The power switch is off.