REAR SEAT ASSEMBLY > INSTALLATION

for Preparation Click here

1. Place the rear seatback assembly RH in the cabin.
   

   NOTICE:

   Be careful not to damage the vehicle body.

2. Install the rear seatback assembly RH with the 2 bolts.
   

   Torque:

   37 N*m{ 375 kgf*cm , 27 ft.*lbf }

3. Engage the fastener to connect the rear No. 1 floor board sub-assembly.
   

1. Place the rear seatback assembly LH in the cabin.
   

   NOTICE:

   Be careful not to damage the vehicle body.

2. Install the rear seatback assembly LH with the 2 bolts.
   

   Torque:

   37 N*m{ 375 kgf*cm , 27 ft.*lbf }

3. Engage the fastener to connect the rear No. 2 floor board sub-assembly.
   

1. Engage the claw to install a new rear seat cushion lock hook.
   

   NOTICE:

   Rear seat cushion lock hooks must not be reused.

   HINT:

   Use the same procedure the LH side and RH side.

1. Place the rear seat cushion assembly in the cabin.
   

   NOTICE:

   Be careful not to damage the vehicle body.

2. Pass the rear center seat outer belt assembly through the rear seat cushion assembly.
   

3. Install the rear center seat outer belt assembly with the bolt.
   

   Torque:

   42 N*m{ 428 kgf*cm , 31 ft.*lbf }

4. Engage the guide as shown in the illustration.
   

5. Pass the rear seat inner with center belt assembly LH and rear seat inner belt assembly through the rear seat cushion assembly as shown in the illustration.
   
   

   
   
   
   
   

   Text in Illustration 

   *1

   Rear Seat Inner Belt Assembly

   *2

   Rear Seat Inner with Center Belt Assembly LH

6. Engage the 2 hooks of the seat cushion to the vehicle body as shown in the illustration.
   

7. Confirm that the seat cushion is firmly installed.
   

   NOTICE:

   When installing the seat cushion, make sure that the seat belt buckles are not under the seat cushion.