REAR SEAT ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE REAR SEAT HEADREST ASSEMBLY


2. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY


3. REMOVE REAR SEAT CUSHION ASSEMBLY


  1. Disengage the hook of the seat cushion from the vehicle body as shown in the illustration.

    NOTICE:
    Follow the instructions below carefully as the cushion frame can be deformed easily.




      B275284E01

    1. Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.
      Text in Illustration 
      *1
      		Hook
      *2
      		Guide
      Standard Measurement 
      *a
      		100 mm (3.94 in.) or less

    2. Repeat the step above for the other hook.

  1. Disengage the guide of the seat cushion from the seatback.



    B221512

  1. Remove the bolt and disconnect the rear center seat outer belt assembly.

  1. Pull out the rear center seat outer belt assembly from the rear seat cushion assembly.

  1. Remove the rear seat cushion assembly.



4. REMOVE REAR SEAT CUSHION LOCK HOOK


    B274369

  1. Disengage the claw and remove the rear seat cushion lock hook.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure the LH side and RH side.



5. REMOVE REAR SEATBACK ASSEMBLY RH

  1. Disengage the fastener and disconnect the rear No. 1 floor board sub-assembly.



    B275063

  1. Remove the 2 bolts and rear seatback assembly RH.

    NOTICE:
    Be careful not to damage the vehicle body.



6. REMOVE REAR SEATBACK ASSEMBLY LH

  1. Disengage the fastener and disconnect the rear No. 2 floor board sub-assembly.



    B275064

  1. Remove the 2 bolts and rear seatback assembly LH.

    NOTICE:
    Be careful not to damage the vehicle body.