GARAGE DOOR OPENER TRANSMITTER > INSTALLATION

for Preparation Click here



1. INSTALL GARAGE DOOR OPENER TRANSMITTER (w/o Sliding Roof)

  1. Install the garage door opener transmitter with the 2 screws.

  1. Connect the connector.

  1. Put the piece of tape back in order to secure the wire harness to the map light assembly.

    HINT:
    If the tape has lost adhesion, use other tape, such as packing tape, with enough adhesion to secure the wire harness to the map light assembly.



2. INSTALL GARAGE DOOR OPENER TRANSMITTER (w/ Sliding Roof)

  1. Install the garage door opener transmitter with the 2 screws.

  1. Engage the clamp.

  1. Connect the connector.



3. INSTALL MAP LIGHT ASSEMBLY

  1. Connect the connector.



    E223659E01

  1. Engage the 3 guides and 4 clips to install the map light assembly as shown in the illustration.

  1. Close the overhead console.