STEERING COLUMN ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT PRELOAD


    C226632E01

  1. Secure the steering column assembly in a vice using aluminum plates and a piece of cloth.
    Text in Illustration 
    *a
    		Wooden Block
    *b
    		Piece of Cloth

    NOTICE:
    1. Do not overtighten the vice, as the steering column assembly may become deformed.
    2. Support the steering column assembly with a wooden block or similar item to ensure that it does not fall.



    C226633E01

  1. Using SST, turn the main shaft and measure the preload.

    SST
    09616-00011  

    Torque:
    Preload:
    0.91 to 1.45 N*m{ 10 to 14 kgf*cm , 8 to 12 in.*lbf }

    If the preload is not as specified, replace the steering column assembly with a new one.



2. INSPECT STEERING COLUMN ASSEMBLY


  1. Inspect the bushings.



      C209250E01

    1. Check that the 2 bushings are securely installed to the steering column assembly.
      Text in Illustration 
      *1
      		Bushing
      If the 2 bushings are installed improperly, replace the steering column assembly with a new one.

    2. Check the 2 bushings for deformation and damage.
      If the bushings are deformed or damaged, replace the steering column assembly with a new one.



  1. Inspect the capsules.



      C232487E01

    1. Check that the 2 capsules are securely installed to the steering column assembly as shown in the illustration.

      Standard Dimension:
      A
      		B
      2 mm (0.0787 in.)
      		17 mm (0.669 in.)

      Text in Illustration 
      *1
      		Capsule
      If the capsules are not positioned as specified, replace the steering column assembly with a new one.

    2. Check the 2 capsules for deformation and damage.
      If either of the capsules is deformed, loose, missing or damaged, replace the steering column assembly with a new one.