BRAKE PEDAL (for RHD) > REMOVAL

for Preparation Click here



1. REMOVE POWER STEERING ECU ASSEMBLY
(Click here)


2. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
(Click here)


3. REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY


    C233726

  1. Disconnect the sensor connector.

  1. Remove the 2 nuts and brake pedal stroke sensor assembly.

    NOTICE:
    1. Do not drop the brake pedal stroke sensor assembly.
    2. If the brake pedal stroke sensor assembly has been dropped, replace the brake pedal stroke sensor assembly with a new one.



4. REMOVE STOP LIGHT SWITCH ASSEMBLY


    E220328

  1. Disconnect the connector.



    E220330

  1. Turn the stop light switch assembly counterclockwise and remove it.



5. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER


6. REMOVE BRAKE PEDAL RETURN SPRING


    C205656

  1. Remove the brake pedal return spring from the brake pedal support assembly and push rod pin.



7. REMOVE PUSH ROD PIN


    C205657

  1. Remove the clip and push rod pin to separate the brake pedal support assembly from the push rod clevis.



8. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    C232385

  1. Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement.



    C224870

  1. Disengage the clamp.



    C205658

  1. Remove the 4 nuts and brake pedal support assembly.



    C209160

  1. Remove the nut from the brake pedal support assembly.



9. REMOVE BRAKE PEDAL PAD