BACK DOOR OPENER SWITCH > REMOVAL

for Preparation Click here



1. REMOVE UPPER BACK DOOR TRIM PANEL ASSEMBLY


    B270183

  1. Using a moulding remover, disengage the 4 clips and 4 claws, and remove the upper back door trim panel assembly.



2. REMOVE BACK DOOR SIDE GARNISH LH


    B270184

  1. Disengage the 2 clips, 2 claws and guide, and remove the back door side garnish LH.



3. REMOVE BACK DOOR SIDE GARNISH RH


    B270185

  1. Disengage the 2 clips, 2 claws and guide, and remove the back door side garnish RH.



4. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    B270186

  1. Using a screwdriver with its tip wrapped in protective tape, slide the handle plate of the back door trim board to disengage it.



    B270188

  1. Disengage the 13 clips and remove the back door trim board assembly.



5. REMOVE BACK DOOR OPENER SWITCH ASSEMBLY


    B270404

  1. Disconnect the connector.

  1. Remove the 2 bolts and back door opener switch assembly.