WASHER MOTOR (for Front Side) > INSPECTION

for Preparation Click here



1. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

  1. Remove the washer jar.

  1. Disconnect the windshield washer motor and pump connector.

    HINT:
    The check should be performed with the windshield washer motor and pump installed on the washer jar.

  1. Fill the washer jar with washer fluid.



    E132855E04

  1. Connect an auxiliary battery positive (+) lead to terminal 1 of the windshield washer motor and pump, and a negative (-) lead to terminal 2.

  1. Check that washer fluid flows from the washer jar.

    OK:
    Washer fluid flows from the washer jar.

    Text in Illustration 
    *a
    		Component without harness connected
    (Windshield Washer Motor and Pump Assembly)
    If the result is not as specified, replace the windshield washer motor and pump assembly.