HEADLIGHT CLEANER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT CLEANER SWITCH ASSEMBLY


E136319E22

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    1 (L) - 4 (B)
    		Headlight cleaner switch on
    		Below 1 Ω
    Headlight cleaner switch off
    		10 kΩ or higher

  1. Connect an auxiliary positive (+) lead from the battery to terminal 3 (ILL+) and a negative (-) lead to terminal 2 (ILL-).

  1. Check that the headlight cleaner switch assembly illumination comes on.

    OK:
    The headlight cleaner switch assembly illumination comes on.

    Text in Illustration 
    *a
    		Component without harness connected
    (Headlight Cleaner Switch Assembly)
    If the result is not as specified, replace the headlight cleaner switch assembly.