CONDENSER > REASSEMBLY

for Preparation Click here

1. Using pliers, install a new cooler dryer to the modulator.
   

2. Apply a sufficient amount of compressor oil to a new O-ring and the fitting surfaces of the cap.
   

   Compressor oil:

   ND-OIL 11 or equivalent
   

3. Using a 14 mm straight hexagon wrench, install the cap to the cooler condenser core.
   

   Text in Illustration 

   *1	14 mm Straight Hexagon Wrench

   Torque:

   2.9 N*m{ 30 kgf*cm , 26 in.*lbf }

   NOTICE:

   1. Keep the O-ring and O-ring fitting surfaces clean from dirt or any foreign matter.
      
   2. Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than ND-OIL 11 or equivalent is used, compressor motor insulation performance may decrease, resulting in a leakage of electric power.
      

1. for LH Side:
   
   

   
   
   

   1. Install the cooler condenser cushion.
      

2. for RH Side:
   
   

   
   
   

   1. Install the cooler condenser cushion.