HOOD > DISASSEMBLY

for Preparation Click here



1. REMOVE HOOD TO RADIATOR SUPPORT SEAL


    B270203

  1. Using a clip remover, disengage the 4 clips and remove the hood to radiator support seal.



2. REMOVE HOOD INSULATOR


    B270204

  1. Using a clip remover, remove the 7 clips.

  1. Disengage the 2 claws and remove the hood insulator.



3. REMOVE WASHER NOZZLE SUB-ASSEMBLY


    E220046E01

  1. Using a screwdriver, disengage the 2 claws and separate the washer nozzle sub-assembly as shown in the illustration.
    Text in Illustration 
    *1
    		Protective Tape

    NOTICE:
    Be careful not to damage the windshield.

    HINT:
    Tape the screwdriver tip before use.



    E220048

  1. Remove the washer nozzle sub-assembly from the washer hose.

    NOTICE:
    Washer nozzles cannot be reused.



4. DISCONNECT WASHER HOSE ASSEMBLY


    B270205

  1. Disengage the 6 clips and disconnect the washer hose assembly.