DTC    P060E    Internal Control Module Throttle Position Performance

for Preparation Click here


MONITOR DESCRIPTION

The ECM monitors the input signals of the No. 1 throttle position sensor. When the ECM monitors the input signal of the No. 1 throttle position sensor, if the input signal and control signal deviate, the DTC is stored.

DTC No.
DTC Detection Condition
Trouble Area
P060E
Either condition is met (1 trip detection logic):
  1. There is an ECM main CPU error.
  2. There is an ECM sub CPU error.
ECM

MONITOR STRATEGY


Required sensors/Components (Main)
ECM
Frequency of operation
Continuous

TYPICAL ENABLING CONDITIONS


DMA communication error
Not detected

TYPICAL MALFUNCTION THRESHOLDS


When one of the following conditions is met:
Condition 1 or 2
1. Difference of main throttle position and sub throttle position
0.3 V or higher
2. Value of main brake switch signal and sub brake switch signal
Different

CONFIRMATION DRIVING PATTERN

  1. Turn the power switch off.
  2. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
  3. Connect the cable to the negative (-) auxiliary battery terminal.
  4. Turn the power switch on (IG) and wait for 10 seconds or more.

INSPECTION PROCEDURE

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).

1.READ OUTPUT DTC (DTC P060E)

  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the tester on.

  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Turn the tester off.

  1. Disconnect the tester.

  1. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) auxiliary battery terminal.

  1. Connect the tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the tester on.

  1. Wait 16 seconds or more.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs.
    Result 
    Result
    		Proceed to
    DTC is not output
    		A
    DTC P060E is output
    		B



B
REPLACE ECM (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)