OIL PRESSURE SWITCH > INSPECTION

for Preparation Click here

1. Disconnect the oil pressure switch connector.
   

2. Start the engine.
   

3. Measure the resistance according to the value(s) in the table below.
   
   

   Standard Resistance:

   
   

   Tester Connection	Condition	Specified Condition
   1 - Switch body	Idling	10 kΩ or higher
   1 - Switch body	Engine stopped	Below 1 Ω

   If the result is not as specified, replace the oil pressure switch assembly.
   

4. Reconnect the oil pressure switch connector.