IGNITION COIL AND SPARK PLUG > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 CYLINDER HEAD COVER


    A248095E01

  1. Remove the 3 clips and No. 2 cylinder head cover.

    NOTICE:
    1. Disengage the clips in the order shown in the illustration.
    2. Attempting to disengage both front and rear clips at the same time may cause the cover to break.
    3. Pull the cover straight up to remove. Attempting to pull the cover forward may cause it to break.



2. REMOVE IGNITION COIL ASSEMBLY


    A212292

  1. Disconnect the 4 ignition coil connectors.

  1. Remove the 4 bolts and 4 ignition coils.

    NOTICE:
    When removing each ignition coil, do not damage the plug cap on the engine head cover opening or the upper edge of the spark plug tube.



3. REMOVE SPARK PLUG


    A216701

  1. Using a 14 mm spark plug wrench, remove the 4 spark plugs.