AIR FUEL RATIO SENSOR > REMOVAL

for Preparation Click here



1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
(Click here)


2. REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL (for LHD)


    C232358

  1. Disengage the 2 claws and remove the No. 1 heater air duct splash shield seal.



3. REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL (for RHD)


    C232376

  1. Disengage the 2 claws and remove the No. 1 heater air duct splash shield seal.



4. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for LHD)


    C232367

  1. Disengage the claw and guide, and remove the No. 2 heater air duct splash shield seal.



5. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for RHD)


    C232375

  1. Disengage the claw and guide, and remove the No. 2 heater air duct splash shield seal.



6. REMOVE COWL BODY MOUNTING REINFORCEMENT LH (for LHD)


    C232357

  1. Remove the 2 bolts and cowl body mounting reinforcement LH.



7. REMOVE COWL BODY MOUNTING REINFORCEMENT RH (for RHD)


    C232377

  1. Remove the 2 bolts and cowl body mounting reinforcement RH.



8. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)


    C232360

  1. Disengage the clamp and separate the wire harness.



    C232359

  1. w/ Wiper Deicer:
    Disengage the 3 clamps, disconnect the connector and separate the wire harness.



    C232361

  1. Remove the 9 bolts and outer cowl top panel sub-assembly.



9. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)


    C232378

  1. Disengage the clamp and separate the wire harness.



    C232379

  1. w/ Wiper Deicer:
    Disengage the 3 clamps, disconnect the connector and separate the wire harness.



    C232380

  1. Remove the 9 bolts and outer cowl top panel sub-assembly.



10. REMOVE NO. 2 CYLINDER HEAD COVER


    A248095E01

  1. Remove the 3 clips and No. 2 cylinder head cover.

    NOTICE:
    1. Disengage the clips in the order shown in the illustration.
    2. Attempting to disengage both front and rear clips at the same time may cause the cover to break.
    3. Pull the cover straight up to remove. Attempting to pull the cover forward may cause it to break.



11. REMOVE AIR FUEL RATIO SENSOR


    A212298

  1. Disconnect the air fuel ratio sensor connector and clamp.



    A216699E03

  1. Using SST, remove the air fuel ratio sensor.

    SST
    09224-00010