HEATED OXYGEN SENSOR > INSTALLATION

for Preparation Click here

1. Using SST, install the heated oxygen sensor onto the front exhaust pipe.
   

   Text in Illustration 

   *a	Fulcrum Length 30 mm
   *b	Fulcrum Length 300 mm

   SST

   09224-00010  
   

   Torque:

   without SST:

   44 N*m{ 449 kgf*cm , 32 ft.*lbf }

   with SST:

   40 N*m{ 408 kgf*cm , 30 ft.*lbf }

   NOTICE:

   1. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.) and a torque wrench with a fulcrum length of 300 mm (11.8 in.) (Click here).
      
   2. The "with SST" torque value is effective when SST is parallel to the torque wrench.
      

2. Connect the wire harness to install the wire harness clamp bracket.
   

3. Install the wire harness clamp bracket with the bolt.
   

   Torque:

   13 N*m{ 127 kgf*cm , 9 ft.*lbf }

4. Install the wire harness bracket.
   

5. Connect the heated oxygen sensor connector.
   

1. Install the front No. 3 engine under cover with the 4 clips.