CAMSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here


HINT:
Although the part name refers to the No. 1 crank position sensor, this procedure is for the camshaft position sensor.



1. INSTALL NO. 1 CRANK POSITION SENSOR


    A158220

  1. Apply a light coat of engine oil to the O-ring on the No. 1 crank position sensor.



    A216700E01

  1. Install the No. 1 crank position sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the No. 1 crank position sensor connector.



2. INSPECT FOR ENGINE OIL LEAK

  1. Put the engine in inspection mode (Click here).

  1. Start the engine.

  1. Check for engine oil leaks from the connected parts of the oil filter cap and oil filter drain plug.



3. INSTALL NO. 2 CYLINDER HEAD COVER


    A248095

  1. Engage the 3 clips to install the cover.

    NOTICE:
    1. Be sure to engage the clips securely.
    2. Do not apply excessive force or hit the cover to engage the clips. This may cause the cover to break.