CAMSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here

HINT:

Although the part name refers to the No. 1 crank position sensor, this procedure is for the camshaft position sensor.

1. Remove the 3 clips and No. 2 cylinder head cover.
   

   NOTICE:

   1. Disengage the clips in the order shown in the illustration.
      
   2. Attempting to disengage both front and rear clips at the same time may cause the cover to break.
      
   3. Pull the cover straight up to remove. Attempting to pull the cover forward may cause it to break.
      

1. Disconnect the No. 1 crank position sensor connector.
   

2. Remove the bolt and No. 1 crank position sensor.