CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANK POSITION SENSOR


    A159394

  1. Apply a light coat of engine oil to the O-ring on the crank position sensor.

  1. Install the crank position sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    Connect the crank position sensor connector.



2. INSPECT FOR ENGINE OIL LEAK

  1. Put the engine in inspection mode (Click here).

  1. Start the engine.

  1. Check for engine oil leaks from the connected parts of the oil filter cap and oil filter drain plug.



3. INSTALL NO. 1 ENGINE UNDER COVER


4. INSTALL REAR ENGINE UNDER COVER RH