ENGINE COOLANT TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here

1. Install the engine coolant temperature sensor through a new gasket.
   

   Text in Illustration 

   *a	Fulcrum Length 25 mm
   *b	Fulcrum Length 180 mm

   SST

   09205-76030  
   

   Torque:

   without SST:

   20 N*m{ 200 kgf*cm , 14 ft.*lbf }

   with SST:

   17 N*m{ 175 kgf*cm , 13 ft.*lbf }

   NOTICE:

   1. The "with SST" torque value is effective when using SST with a fulcrum length of 25 mm (0.984 in.) and a torque wrench with a fulcrum length of 180 mm (7.09 in.) (Click here).
      
   2. The "with SST" torque value is effective when SST is parallel to the torque wrench.
      

2. Connect the engine coolant temperature sensor connector.
   

1. Install the inverter reserve tank assembly with the 2 bolts.
   

   Torque:

   10 N*m{ 102 kgf*cm , 7 ft.*lbf }