THROTTLE BODY > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


2. DRAIN COOLANT (for Engine)

NOTICE:
Do not remove the reserve tank cap and radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the local regulations.



  1. Remove the reserve tank cap and drain the coolant.


    A251091E01


    Text in Illustration 
    *1
    		Reserve Tank Cap
    		*2
    		Radiator Drain Cock Plug



3. REMOVE RADIATOR SUPPORT OPENING COVER


    B269819

  1. Remove the 9 clips and radiator support opening cover.



4. REMOVE NO. 2 CYLINDER HEAD COVER


    A248095E01

  1. Remove the 3 clips and No. 2 cylinder head cover.

    NOTICE:
    1. Disengage the clips in the order shown in the illustration.
    2. Attempting to disengage both front and rear clips at the same time may cause the cover to break.
    3. Pull the cover straight up to remove. Attempting to pull the cover forward may cause it to break.



5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A247952

  1. Disconnect the mass air flow meter connector.



    A247953

  1. Separate the water hose from the hose clamp.

  1. Release the 2 clamps.

  1. Loosen the hose clamp and remove the air cleaner cap.



6. REMOVE INLET AIR CLEANER ASSEMBLY


    A247954

  1. Separate the water hose from the hose clamp.



    A247955

  1. Separate the wire harness clamp from the inlet air cleaner assembly.

  1. Remove the 2 bolts, 2 clips and inlet air cleaner assembly.



7. REMOVE AIR CLEANER CASE

  1. Remove the air cleaner filter element sub-assembly.



    A247956

  1. Separate the hose from the hose clamp.

  1. Remove the 2 bolts and air cleaner case.



8. REMOVE AIR CLEANER HOSE ASSEMBLY


    A247957

  1. Loosen the hose clamp and separate the ventilation hose.

  1. Unlock the hose clamp and remove the air cleaner hose assembly.



9. REMOVE THROTTLE BODY ASSEMBLY


    A247948

  1. Disconnect the throttle body connector and 2 water by-pass hoses.

  1. Remove the 2 bolts, 2 nuts and throttle body assembly.



    A212317

  1. Remove the gasket from the intake manifold.