STEERING PAD SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL STEERING PAD SWITCH ASSEMBLY

  1. Engage the 2 claws, 2 pins and 2 guides to install the steering pad switch assembly.

  1. Install the 2 screws.

    Torque:
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf }



    C233344E01

  1. Install the clamp.
    Text in Illustration 
    *1
    		Clamp
    *2
    		Guide

  1. Pass the wire harness through the guide.

  1. Connect the steering pad switch connector to the spiral cable.



    C233342

  1. Pass the wire harness over the 2 guides.



2. INSTALL HORN BUTTON ASSEMBLY
(Click here)