STEERING ANGLE SENSOR > INSTALLATION

for Preparation Click here

1. Install the spiral cable with sensor sub-assembly (Click here).
   

   NOTICE:

   1. Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).
      
   2. Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the auxiliary battery connected and the power switch on (IG).
      
   3. Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
      
   4. Do not remove the steering angle sensor from the spiral cable.
      

NOTICE:

If the steering column cover is installed in the incorrect order, it will not be possible to assemble the steering column cover.

1. Engage the 2 claws to install the steering column cover (upper side).
   

2. Engage the 4 clips and 2 guides to the steering column cover (upper side).
   

3. Engage the 4 claws to install the steering column cover (lower side).
   

4. Engage the 2 claws.
   

   HINT:

   Spread the claws and press the area around the claws to engage them.

5. Install the 2 screws.
   

   Torque:

   2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

NOTICE:

Do not adjust the spiral cable with the auxiliary battery connected and the power switch on (IG).

1. Check that the power switch is off.
   

2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
   

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

3. Rotate the spiral cable counterclockwise slowly by hand until it stops.
   

   NOTICE:

   Do not turn the spiral cable using the airbag wire harness.

4. Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
   

   Text in Illustration 

   *A	w/o Steering Heater
   *B	w/ Steering Heater
   *1	Alignment Mark

   NOTICE:

   Do not turn the spiral cable using the airbag wire harness.

   HINT:

   The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.