FRONT BUMPER > INSTALLATION

for Preparation Click here



1. INSTALL FRONT BUMPER ASSEMBLY

  1. w/ Headlight Cleaner System:

    1. Connect the headlight cleaner hose.

  1. w/ Wire Harness:

    1. Connect the connector.



    B269830

  1. Engage the 2 claws and install the front bumper assembly as shown in the illustration.



    B269828

  1. Engage the 2 claws to install the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Install the 2 clips.

  1. Install the 2 bolts.

  1. Install the 6 screws.

  1. Install the front bumper seal bracket.

    NOTICE:
    Do not pull the front bumper assembly after the front bumper seal bracket is installed, or the front bumper assembly may be damaged.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Install the screw.

    HINT:
    Use the same procedure for the RH side and LH side.



    B271157E01

  1. Install the 2 pin hold clips.
    Text in Illustration 
    *1
    		Correct
    *2
    		Incorrect

    NOTICE:
    Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.

    HINT:
    Use the same procedure for the RH side and LH side.



2. INSTALL HOOD CENTER CUSHION

  1. Install the 2 hood center cushions.



3. INSTALL RADIATOR SUPPORT OPENING COVER

  1. Install the radiator support opening cover with the 9 clips.



4. INSTALL FRONT SPOILER COVER (w/ Front Spoiler)

  1. Install the front spoiler cover with the 8 screws.



5. ADD WASHER FLUID (w/ Headlight Cleaner System)

  1. Add washer fluid to the washer jar.



6. ADJUST FOG LIGHT ASSEMBLY (w/ Fog Light)
(Click here)