WASHER MOTOR (for Rear Side) > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL RH


2. REMOVE FRONT FENDER LINER RH


    E220607E01

  1. Using a screwdriver, turn each pin 90 degrees counterclockwise and remove the 2 pin hold clips.



    E220608

  1. Using a 4 mm hexagon wrench, remove the 3 screws.



    E220609E01

  1. Remove the 6 screws and bolt.

  1. Remove the 6 clips and 2 grommets and front fender liner RH.

    HINT:
    The grommets need to be replaced with new ones because they will break when they are removed.

    Text in Illustration 
    *1
    		Grommet



3. DRAIN WASHER FLUID


    E220057

  1. Disconnect the washer hose from the rear washer motor and pump assembly, and drain the washer fluid.

    HINT:
    Use a container to collect the washer fluid.



4. REMOVE REAR WASHER MOTOR ASSEMBLY


    E220058

  1. Disconnect the connector.

  1. Remove the rear washer motor and pump assembly as shown in the illustration.

    HINT:
    Use a container to collect the washer fluid.