DTC    C1626    Steering Angle Sensor Failure

for Preparation Click here


DESCRIPTION

This DTC is stored if the parking assist ECU receives a signal via CAN communication from the spiral with sensor cable sub-assembly that indicates an internal malfunction.

DTC No.
DTC Detection Condition
Trouble Area
C1626
A fail flag is transmitted from the steering angle sensor.
  1. Steering sensor (spiral with sensor cable sub-assembly)
  2. Parking assist ECU

INSPECTION PROCEDURE

NOTICE:
  1. When "System initializing" is displayed on the multi-display after disconnecting the cable from the negative (-) auxiliary battery terminal, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).
  3. After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).

1.REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

  1. Replace the spiral with sensor cable sub-assembly (Click here).


NEXT


2.CHECK DTC OUTPUT

  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result:
    Result
    		Proceed to
    DTC C1626 is output
    		A
    No DTC is output
    		B



B
END
A

REPLACE PARKING ASSIST ECU (Click here)