ROCKER PANEL MOULDING > INSTALLATION

for Preparation Click here



1. INSTALL BODY ROCKER PANEL MOULDING ASSEMBLY


  1. Install 9 new clips (rocker panel moulding clips) to the body rocker panel moulding assembly as shown in the illustration.


    B270402

  1. Engage the 9 clips to install the body rocker panel moulding assembly.

    HINT:
    Install the front side body rocker panel moulding assembly inside the front fender liner.

  1. Install the 4 clips (No. 2 side mudguard retainers) and 3 clips (side mudguard retainers).

  1. Install the 2 screws.

  1. Using a 4 mm hexagon wrench, install the hexagon screw.



    B270394

  1. Engage the 2 claws and install the rocker panel moulding cover.

    HINT:
    Use the same procedure for the front side and rear side.

  1. Install the new grommet.

  1. Using a 4 mm hexagon wrench, install the 3 hexagon screws.



2. INSTALL REAR WHEEL HOUSE FRONT PLATE

  1. Install the rear wheel house front plate with the screw and 2 clips.