ROCKER PANEL MOULDING > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL HOUSE FRONT PLATE


    B270376

  1. Remove the 2 clips.

  1. Remove the screw and remove the rear wheel house front plate.



2. REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY


    B270384E01

  1. Put protective tape around the body rocker panel moulding assembly.
    Text in Illustration 
    *1
    		Protective Tape



    B275943

  1. Using a 4 mm hexagon wrench, remove the 3 hexagon screws.



    B275944

  1. Remove the grommet.



    B270388E01

  1. Using a screwdriver with the tip wrapped with protective tape, disengage the 2 claws and remove the rocker panel moulding cover.
    Text in Illustration 
    *1
    		Protective Tape

    HINT:
    Use the same procedure for the front side and rear side.



    B270387

  1. Using a 4 mm hexagon wrench, remove the hexagon screw.



    B270395

  1. Remove the 2 screws.



    B270396

  1. Remove the 3 clips (side mudguard retainers).

  1. Remove the 4 clips (No. 2 side mudguard retainers).



    B270403

  1. Disengage the 9 clips to remove the body rocker panel moulding assembly.



  1. Remove the 9 clips (rocker panel moulding clips) as shown in the illustration.


    B270401