CAMSHAFT OIL CONTROL VALVE > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 CYLINDER HEAD COVER


    A248095E01

  1. Remove the 3 clips and No. 2 cylinder head cover.

    NOTICE:
    1. Disengage the clips in the order shown in the illustration.
    2. Attempting to disengage both front and rear clips at the same time may cause the cover to break.
    3. Pull the cover straight up to remove. Attempting to pull the cover forward may cause it to break.



2. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY


    A212291

  1. Disconnect the camshaft timing oil control valve assembly connector.

  1. Remove the bolt and camshaft timing oil control valve assembly.



    A158212

  1. Remove the O-ring from the camshaft timing oil control valve assembly.