LIGHT CONTROL RHEOSTAT > REMOVAL

for Preparation Click here



1. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    B274561

  1. Disconnect the front door opening trim weatherstrip.

  1. Remove the residual weatherstrip sealant from the body of the vehicle using cleaner.

    NOTICE:
    Remove the sealant completely. Any residual sealant may transfer to other areas of the vehicle when removing/installing the interior parts.



2. REMOVE INSTRUMENT SIDE PANEL


    B263501

  1. Using a moulding remover, disengage the 3 claws, clip and 4 guides, and remove the instrument side panel LH.



3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    B263505

  1. Using a moulding remover, disengage the 8 claws and clip.

  1. Disconnect each connector and remove the lower instrument panel finish panel sub-assembly.



4. REMOVE LIGHT CONTROL RHEOSTAT


    E218679

  1. Disengage the 2 claws and remove the light control rheostat.