ELECTRICAL KEY OSCILLATOR (for Center Floor) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 ELECTRICAL KEY OSCILLATOR

  1. Connect the connector.

  1. Install the No. 2 electrical key oscillator with the bolt.

    NOTICE:
    Be careful when installing the electrical key oscillator. If the oscillator is dropped, replace it with a new one.

  1. Install the 2 clips to the floor carpet.



2. INSTALL REAR SEAT CUSHION LOCK HOOK


    B274370

  1. Engage the claw to install a new rear seat cushion lock hook.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure the LH side and RH side.



3. INSTALL REAR SEAT CUSHION ASSEMBLY

  1. Place the rear seat cushion assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.



    B274151

  1. Pass the rear center seat outer belt assembly through the rear seat cushion assembly.

  1. Install the rear center seat outer belt assembly with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



    B275285

  1. Engage the guide as shown in the illustration.



  1. Pass the rear seat inner with center belt assembly LH and rear seat inner belt assembly through the rear seat cushion assembly as shown in the illustration.


    B274150E01


    Text in Illustration 
    *1
    		Rear Seat Inner Belt Assembly
    		*2
    		Rear Seat Inner with Center Belt Assembly LH



    B274367

  1. Engage the 2 hooks of the seat cushion to the vehicle body as shown in the illustration.

  1. Confirm that the seat cushion is firmly installed.

    NOTICE:
    When installing the seat cushion, make sure that the seat belt buckles are not under the seat cushion.