FRONT BLOWER MOTOR > INSTALLATION

for Preparation Click here



1. INSTALL FRONT BLOWER MOTOR SUB-ASSEMBLY (w/o PTC Heater)

  1. Install the front blower motor sub-assembly with the 3 screws.

    NOTICE:
    Do not reuse the front blower motor sub-assembly if it has been damaged or received an impact.

  1. Engage the clamp and connect the connector.



2. INSTALL FRONT BLOWER MOTOR SUB-ASSEMBLY (w/ PTC Heater)

  1. Install the front blower motor sub-assembly with the 3 screws.

    NOTICE:
    Do not reuse the front blower motor sub-assembly if it has been damaged or received an impact.

  1. Install the quick heater connector screw.

  1. Reattach the felt tape.

  1. Engage the clamp and connect the connector.



3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

  1. Connect the connector.

  1. Engage the clamp.

  1. Engage the guide, claw and 2 clips to install the No. 2 instrument panel under cover sub-assembly.



4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

  1. Connect the connector.

  1. Engage the clamp.

  1. Engage the 2 guides, claw and 2 clips to install the No. 2 instrument panel under cover sub-assembly.