HEIGHT CONTROL SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

  1. Engage the 2 guides and install the rear height control sensor sub-assembly with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the connector.

  1. Engage the clamp.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE

  1. Engage the 4 claws and 2 guides to install the rear floor board upper No. 3 plate.



4. INSTALL DECK FLOOR BOX RH

  1. Engage the 6 guides.

  1. Install the deck floor box RH with the clip.



5. INSTALL REAR NO. 3 FLOOR BOARD

  1. Install the rear No. 3 floor board.



6. INSTALL REAR DECK FLOOR BOX

  1. Install the rear deck floor box.



7. INSTALL REAR NO. 2 FLOOR BOARD

  1. Install the rear No. 2 floor board.



8. HEIGHT CONTROL SENSOR SIGNAL INITIALIZATION
(Click here)


9. ADJUST HEADLIGHT AIMING
(Click here)