HEIGHT CONTROL SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (Click here).



2. REMOVE REAR NO. 2 FLOOR BOARD

  1. Remove the rear No. 2 floor board.



3. REMOVE REAR DECK FLOOR BOX

  1. Remove the rear deck floor box.



4. REMOVE REAR NO. 3 FLOOR BOARD

  1. Remove the rear No. 3 floor board.



5. REMOVE DECK FLOOR BOX RH


    B270546

  1. Remove the clip.

  1. Disengage the 6 guides and remove the deck floor box RH.



6. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE


    B270547

  1. Disengage the 4 claws and 2 guides, and remove the rear floor board upper No. 3 plate.



7. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



8. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY


    E220665E01

  1. Disengage the clamp.

  1. Disconnect the connector.
    Text in Illustration 
    *1
    		Clamp
    *2
    		Guide

  1. Remove the 2 bolts.

  1. Disengage the 2 guides and remove the rear height control sensor sub-assembly.

    NOTICE:
    Do not drop the rear height control sensor sub-assembly. If it is dropped, replace it with a new one.