HEADLIGHT LEVELING ECU (for LHD) > INSTALLATION

for Preparation Click here

1. Engage the guide.
   

2. Install the headlight leveling ECU assembly with the nut.
   

3. Connect the connector.
   

1. Connect the connector.
   

2. Engage the clamp.
   

3. Engage the 5 claws.
   

4. Install the glove compartment door assembly with the 4 screws <C>.
   

1. Check that the power switch is off.
   

2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
   

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

3. Connect the airbag connector to the lower No. 2 instrument panel airbag assembly.
   

   NOTICE:

   When connecting any airbag connector, take care not to damage the airbag wire harness.

4. Push in the lock to install the airbag connector.
   

5. Temporarily install the lower No. 2 instrument panel airbag assembly with the 6 claws and 2 guides.
   

6. Install the 3 bolts.
   

   Torque:

   10 N*m{ 102 kgf*cm , 7 ft.*lbf }

   NOTICE:

   Confirm that the lower No. 2 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

1. Connect the connector.
   

2. Engage the clamp.
   

3. Engage the guide, claw and 2 clips to install the No. 2 instrument panel under cover sub-assembly.
   

1. Connect the connector.
   

2. Engage the 4 guides, clip and 3 claws to install the instrument side panel RH.
   

1. Align the alignment mark (light blue) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip RH.
   

   Text in Illustration 

   *a	Alignment Mark (Light blue)

   NOTICE:

   After installation, check that the corners fit correctly.

HINT:

Use the same procedure for the RH side and LH side (Click here).

HINT:

Use the same procedure for the RH side and LH side (Click here).

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

1. Engage the 4 claws and 2 guides to install the rear floor board upper No. 3 plate.
   

1. Engage the 6 guides.
   

2. Install the deck floor box RH with the clip.
   

1. Install the rear No. 3 floor board.
   

1. Install the rear deck floor box.
   

1. Install the rear No. 2 floor board.