DTC    C1440/98    Unusual Bank Angle Detected

for Preparation Click here


DESCRIPTION

If the skid control ECU determines that the vehicle is being driven at a steep bank angle, the skid control ECU stores DTC C1440/98 while VSC operation is temporarily disabled.
It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes.

DTC Code
INF Code
DTC Detection Condition
Trouble Area
C1440/98
-
Driving at a steep bank angle.
Yaw rate and acceleration sensor

INSPECTION PROCEDURE

1.CHECK DTC

  1. Clear the DTCs (Click here).

  1. Perform a road test.

  1. Check if the same DTC is recorded (Click here).

    Result:

    Result
    		Proceed to
    DTC (C1440/98) is output
    		A
    DTC (C1440/98) is not output
    		B
    Yaw rate and acceleration sensor DTC is output
    		C



B
END

C
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)
A


2.CLEAR DTC

  1. Clear the DTCs (Click here).

    HINT:
    1. If the skid control ECU determines that the vehicle is being driven at a steep bank angle, the skid control ECU stores DTC C1440/98 while VSC operation is temporarily disabled.
    2. It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes.


NEXT

END