TEMPERATURE SWITCH > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


2. REMOVE NO. 2 CYLINDER HEAD COVER


    A248095E01

  1. Remove the 3 clips and No. 2 cylinder head cover.

    NOTICE:
    1. Disengage the clips in the order shown in the illustration.
    2. Attempting to disengage both front and rear clips at the same time may cause the cover to break.
    3. Pull the cover straight up to remove. Attempting to pull the cover forward may cause it to break.



3. DRAIN COOLANT (for Engine)

NOTICE:
Do not remove the reserve tank cap and radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the local regulations.



  1. Remove the reserve tank cap and drain the coolant.


    A251091E01


    Text in Illustration 
    *1
    		Reserve Tank Cap
    		*2
    		Radiator Drain Cock Plug



4. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    A251264

  1. Disconnect the connector.



    A251265

  1. Using a union nut wrench (19 mm), remove the engine coolant temperature sensor.

    NOTICE:
    Do not apply any excessive force to the heater pipe when removing the engine coolant temperature sensor.