REAR LOWER ARM > INSPECTION

for Preparation Click here



1. INSPECT REAR NO. 1 SUSPENSION ARM ASSEMBLY


  1. Inspect the turning torque of the ball joint.



      C234181

    1. Secure the rear No. 1 suspension arm assembly between aluminum plates in a vise.

      NOTICE:
      Do not overtighten the vise.

    2. Install the installation nut to the rear No. 1 suspension arm stud.

    3. Move the stud back and forth 5 times. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the 5th turn.

      Turning torque:
      0.5 to 3.4 N*m (5.1 to 34 kgf*cm, 4.4 to 30 in.*lbf)

      If the turning torque is not within the specified range, replace the rear No. 1 suspension arm assembly with a new one.

  1. Inspect the dust cover.

    1. Check the dust covers for cracks or grease leakage.