REAR STABILIZER BAR > INSTALLATION

for Preparation Click here



1. INSTALL REAR STABILIZER BUSHING


    C234399E01

  1. Install the 2 rear stabilizer bushings to the outside of the stoppers on the rear stabilizer bar.
    Text in Illustration 
    *a
    		Stopper



2. INSTALL REAR NO. 1 STABILIZER BAR BRACKET


    C234402E01

  1. Install the rear No. 1 stabilizer bar bracket to the rear stabilizer bushing.
    Text in Illustration 
    *a
    		Identification Mark
    V100135
    		Rear of the Vehicle

    NOTICE:
    Ensure that the identification mark is on the right side of the vehicle.



3. INSTALL REAR STABILIZER BAR


    C232808E01

  1. Install the rear stabilizer bar, 2 rear stabilizer bushings and rear No. 1 stabilizer bar bracket to the rear suspension member sub-assembly with the 4 bolts.
    Text in Illustration 
    *a
    		Identification Mark
    V100136
    		Front of the Vehicle

    Torque:
    78 N*m{ 795 kgf*cm , 58 ft.*lbf }

    NOTICE:
    Ensure that the identification mark is on the right side of the vehicle.



4. INSTALL REAR STABILIZER LINK ASSEMBLY LH

NOTICE:
Since the rear stabilizer link assembly LH, rear stabilizer cushions and nut (B) are not reusable, new parts must be installed.



    C211882

  1. Install a new rear stabilizer link assembly LH and 2 new rear stabilizer cushions to the rear No. 2 suspension arm assembly with a new nut (B) as shown in the illustration.
    Text in Illustration 
    V100135
    		Nut (A)
    V100136
    		Nut (B)

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    NOTICE:
    Be sure to install the rear stabilizer cushions in the correct direction as shown in the illustration.

  1. Install the rear stabilizer link assembly LH to the rear stabilizer bar with the nut (A).

    Torque:
    95 N*m{ 969 kgf*cm , 70 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon socket wrench to hold the stud bolt.



    C211884E01

  1. Adjust the rear stabilizer link assembly LH so that A and B are parallel as shown in the illustration.



5. INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as the LH side.



6. INSTALL REAR SUSPENSION MEMBER BRACE LH

  1. Install the rear suspension member brace LH to the rear suspension member sub-assembly with the 3 bolts.

    Torque:
    32 N*m{ 326 kgf*cm , 24 ft.*lbf }



7. INSTALL REAR SUSPENSION MEMBER BRACE RH

HINT:
Perform the same procedure as the LH side.