CENTER AIRBAG SENSOR ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE REAR CONSOLE BOX ASSEMBLY
(Click here)


2. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
(Click here)


3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B269927

  1. Turn the shift lever knob counterclockwise and remove the shift lever knob sub-assembly.



4. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY


    B269931

  1. Disengage the 6 claws and 2 guides.

  1. Disengage the clamp.

  1. Disconnect each connector and remove the integration control and panel assembly.



5. REMOVE CONSOLE BOX INSERT


    B269943

  1. Disengage the 2 clips and 2 claws, and remove the console box insert.



6. REMOVE CONSOLE BOX LH


    B269945

  1. Remove the bolt <A>.

  1. Using a clip remover, remove the clip.

  1. Using a clip remover, disengage the 3 clips.

  1. Disengage the 2 claws and guide, and remove the console box LH.



7. REMOVE FRONT NO. 2 CONSOLE BOX INSERT


    B269947

  1. Disengage the 5 claws and remove the front No. 2 console box insert.



8. REMOVE CONSOLE BOX RH


    B269949

  1. Remove the bolt <A>.

  1. Using a clip remover, remove the clip.

  1. Using a clip remover, disengage the 3 clips.

  1. Disengage the 2 claws and guide, and remove the console box RH.



9. REMOVE NO. 3 CONSOLE BOX MOUNTING BRACKET (w/ Navigation System for DVD)


    B269951E01

  1. Disengage the clamp.
    Text in Illustration 
    *1
    		Clamp
    *2
    		Guide

  1. Remove the 4 bolts <A>.

  1. Disengage the 3 guides and remove the No. 3 console box mounting bracket.



10. REMOVE MULTI-MEDIA MODULE ASSEMBLY (w/ Navigation System for DVD)


    E220517

  1. Disconnect the 2 connectors.

  1. Remove the 4 bolts and multi-media module assembly.



11. REMOVE NO. 5 DISC PLAYER BRACKET (w/ Navigation System for DVD)


    C233744

  1. Disengage the clamp.

  1. Remove the 4 bolts and No. 5 disc player bracket.



12. REMOVE AIRBAG SENSOR ASSEMBLY

  1. Check that the power switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



    B268555

  1. Disconnect the connectors from the airbag sensor assembly as shown in the illustration.

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.



    B268557

  1. Remove the 3 bolts and airbag sensor assembly.