DTC    CB-10    System Microcomputer Malfunction

DTC    CB-11    Media Interface Microcomputer Malfunction

DTC    CB-12    CD-LSI Malfunction

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
CB-10
System microcomputer malfunction
  1. Multi-media interface ECU assembly
  2. "iPod" or USB device
CB-11
Media interface microcomputer malfunction
CB-12
CD-LSI (Large Scale Integration) malfunction

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs.

1.REPLACE USB DEVICE OR "iPod"

  1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

  1. Turn the power switch off.

    HINT:
    When one of these DTCs has been stored, it is necessary to turn off the power switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the power switch on (ACC).

  1. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.


NEXT


2.CLEAR DTC

  1. Clear the DTCs (Click here).


NEXT


3.RECHECK FOR DTC

  1. Recheck for DTCs and check if the same DTC is output again.

    HINT:
    If DTCs are detected frequently, replace the multi-media interface ECU assembly.

    OK:
    No DTCs are output.



NG
REPLACE MULTI-MEDIA INTERFACE ECU ASSEMBLY (Click here)
OK

USB DEVICE OR "iPod" WAS DEFECTIVE